Description
RCBS Bullet Puller Collet has been redesigned to make it easier than ever for reloaders to pull jacketed bullets from brass without damaging either component.
This puller uses standard 7/8-inch-14 threads to fit almost all single-stage reloading presses. It works with jacketed bullets from calibers ranging from .17 to .50 cal when equipped with the appropriate collet (sold separately).
To use, set up your die in the press with the right caliber collet, place the cartridge in the press, lift the ram, tighten the collet, and lower the ram to pull the bullet out. Note: designed for jacketed bullets and not for rimfire ammunition.